The effect of silica desiccation under different storage conditions on filter-immobilized environmental DNA

Objective Silica gel beads have promise as a non-toxic, cost-effective, portable method for storing environmental DNA (eDNA) immobilized on filter membranes. Consequently, many ecological surveys are turning to silica bead filter desiccation rather than ethanol preservation. However, no systematic evaluation of silica bead storage conditions or duration past 1 week has been published. The present study evaluates the quality of filter-immobilized eDNA desiccated with silica gel under different storage conditions for over a year using targeted quantitative real-time polymerase chain reaction (qPCR)-based assays. Results While the detection of relatively abundant eDNA target was stable over 15 months from either ethanol- or silica gel-preserved filters at − 20 and 4 °C, silica gel out-performed ethanol preservation at 23 °C by preventing a progressive decrease in eDNA sample quality. Silica gel filter desiccation preserved low abundance eDNA equally well up to 1 month regardless of storage temperature (18, 4, or − 20 °C). However only storage at − 20 °C prevented a noticeable decrease in detectability at 5 and 12 months. The results indicate that brief storage of eDNA filters with silica gel beads up to 1 month can be successfully accomplished at a range of temperatures. However, longer-term storage should be at − 20 °C to maximize sample integrity. Supplementary Information The online version contains supplementary material available at 10.1186/s13104-021-05530-x.


Introduction
Over the past decade, techniques used to detect environmental DNA (eDNA)-genetic material present in environmental samples from secretions, excretions, exogenous sloughing of eukaryotic cells, or from microscopic organisms [1]-have surged in use by academic, government, conservation, and development sectors for providing cost-effective information about at-risk and invasive species in natural and managed ecosystems [2][3][4][5]. In eDNA-based surveys, a common technique is to immobilize eDNA from water samples on filter membranes, extract the DNA, and perform targeted taxa quantitative real-time polymerase chain reaction (qPCR) analyses. Ideally, these filters can be stored for some time or archived prior to DNA analysis. Filters are typically immersed in high percentage, molecular grade ethanol to prevent sample degradation during storage [6]. Immersion of filters in ethanol at room temperature for up to 2 weeks gave better eDNA performance than directly freezing filters with no preservation or extracting DNA from filters within 5 h of filtration at room temperature [7]. While relatively straightforward to use, the use of ethanol presents several challenges in that it is a Open Access BMC Research Notes *Correspondence: chelbing@uvic.ca 1 Department of Biochemistry and Microbiology, University of Victoria, Victoria, BC, Canada Full list of author information is available at the end of the article dangerous good (volatile, flammable, and poisonous) requiring special shipping permits, and adds considerable bulk and weight to the field sample. However, recently, the use of silica gel beads as a filter desiccant have been suggested as a lightweight alternative to ethanol immersion [8][9][10]. Despite this suggestion, little empirical work has been published evaluating silica gel filter storage conditions under different temperatures over periods greater than 1 week.
The present study evaluates the quality of filter-immobilized eDNA desiccated with silica gel beads for over a year under different storage temperatures. In the first experiment, targeted detection of relatively abundant (~ 50,000 copies per reaction) eDNA from an outdoor freshwater tank was examined using filters preserved in ethanol or silica gel beads for up to 15 months at 23, 4, and − 20 °C. In the second experiment, low abundance (~ 500 copies per reaction) eDNA targets from water samples spiked with a dilute tissue slurry were tracked using two separate targeted qPCR assays on filters preserved by silica gel beads for up to 12 months at 18, 4, and − 20 °C.

Animal care and handling
A single premetamorphic American bullfrog (Rana [Lithobates] catesbeiana) tadpole was used as a tissue source to create a standard slurry detailed below. The tadpole was euthanized using 0.1% (w/v) tricaine methanesulfonate (Syndel Laboratories, Nanaimo, BC, Canada) buffered in 25 nM sodium bicarbonate (Sigma Aldrich, Canada).

Filter storage in silica gel beads
All procedures were performed in an amplicon-free area and the benchtop was wiped with 10% bleach (v/v) (Javex 12 by Clorox) solution followed by 70% ethanol (v/v) prior to setup. Personnel wore nitrile gloves, safety glasses, and a lab coat. In all procedures, forceps were submerged in 50% bleach (v/v) and thoroughly rinsed with distilled water and dried between sample handling events. Sample water (details below) was vacuum filtered through Nalgene analytical test filter funnels with 0.45 μm mixed cellulose ester filters (Thermofisher Scientific Inc., Mississauga, ON, Cat#145-2045). Mixed cellulose ester (cellulose nitrate and acetate mixture) was chosen because it, along with cellulose nitrate, empirically gave the highest DNA yield when comparing filter membrane compositions [7,9,11,12]. The vacuum was maintained for 1 min after the sample had passed through to remove excess water. Filters were preserved whole to replicate the effects of disturbance during repeat DNA isolations where one-quarter of a filter is broken off for every round of DNA isolation.
Using forceps, the filter was folded in half with the filtride facing inward and inserted into a pre-labelled Manila paper coin envelope (Fig. 1). This was then inserted into a small sealable plastic bag to which 15-30 mL of color-indicating 2-4 mm rechargeable silica gel beads (Dry & Dry, Amazon, Canada; Product #CRH-16036) were added. The orange beads will turn dark Fig. 1 Recommended method for storing an eDNA filter sample using silica gel beads. A filter membrane is folded in half with the filtride side in and placed inside a paper coin envelope. This, in turn, is placed in a sealable plastic bag containing silica gel beads, the air removed and firmly sealed before storage. It is easy to monitor the moisture content of the sample as the orange beads turn dark green when there is too much moisture and need to be replaced or the beads regenerated as per the manufacturer's instructions green when they are 50-60% water saturated allowing for easy monitoring of desiccation conditions during storage. The coin envelope prevents direct contact between the filter and the silica beads and protects the filter from damage. The filters, thus prepared, were stored in the dark at the indicated temperatures.

Experiment 1: Comparison between ethanol and silica filter preservation of relatively abundant eDNA at three holding temperatures over time
One-litre samples (n = 2-3 per temperature group) of recirculated water were obtained on the same day at the University of Victoria's Aquatics Facility from an outdoor fiberglass tank used for holding bullfrog tadpoles fed daily with Spirulina. Water was filtered and the filters handled as described above for silica gel desiccation above or folded in quarters and placed into a 2 mL microcentrifuge tube containing 95% molecular-grade ethanol [8]. The tube was filled with ethanol and wrapped in Parafilm for storage to prevent evaporation. One set of filters were not preserved and rather set aside for immediate processing. DNA was extracted from the filters immediately or after 1, 4, 8, or 15 months of storage at − 20, 4, and 23 °C. At each time-point, each filter was individually removed from its coin envelope in a laminar flow hood, and a quarter partitioned off at room temperature. The remaining filter was returned to its coin envelope or the tube containing ethanol and placed back into its designated storage condition.

Experiment 2: Effect of holding temperature and time on low abundance eDNA on silica-preserved filters
A standard eDNA slurry was prepared ensuring that the target DNA was present but diluted to an abundance closer to typical eDNA samples. The slurry was created by mixing a 4 mm diameter dorsal tail fin punch taken from an American bullfrog (Rana (Lithobates) catesbeiana) tadpole, a 4 mm diameter flake of Spirulina with 1 mL DNase-free TE buffer pH 8. The mixture was homogenized for 6 min at 24 Hz in a Retsch MM301 mixer mill (ThermoFisher Scientific Inc.) in microtubes containing a 3 mm tungsten carbide bead (the mixer mill rack was rotated 180° halfway through homogenization) to create a standard slurry (Additional file 1: Figure S1).
Since the purpose of this experiment was to monitor DNA integrity on filters over time measured by C t values, it was crucial for all initial time points to have a positive detection. To determine the lowest concentration of DNA that resulted in 100% positive detection in all technical replicates, a tenfold serial dilution test using recirculated fresh water from the Aquatics Facility was carried out and the appropriate slurry dilution (10 -6 ) was selected to create a 2 L 10× working stock (Additional file 1). Three hundred millilitre working stock was added to each of five replicates of 2700 mL recirculated water and each replicate was further divided into 1 L aliquots that were individually vacuum filtered (Additional file 1). The result was three filters with identical filtride which were distributed between each storage temperature (18, 4, and − 20 °C; Additional file 1). Each 1 L experimental sample was matched by a 1 L negative control sample of bottled distilled water (Equate brand, Walmart) for a total sample number of 30. In a laminar flow hood, all filters were quartered using forceps. Each quarter filter was stored in a separate coin envelope to allow for consistent preservation conditions and preserved using silica gel beads as described above.

DNA isolation and analysis
The DNA from one quarter of each filter was isolated using the DNeasy Blood and Tissue kit (QIAGEN Inc., Mississauga, ON, Canada; Cat# 69506) following the procedure outlined in [13].
The test for relatively abundant chloroplast signal using the IntegritE-DNA ™ assay as described previously [13,14] and the tests for low abundance bullfrog DNA (eFrog3 and eLICA1) were previously validated and described [13]. An additional validation step for these two assays was performed using gBlocks ® synthetic DNA ordered from Integrated DNA Technologies (Coralville, Iowa, United States) following the method outlined previously [14]. This allowed creation of a standard curve relating qPCR cycle threshold values to starting copy numbers, and objective, standardizable comparison of assay results. All qPCR tests followed the same run conditions outlined in [13] except that the eFrog3 assay 30 s annealing step was adjusted to 60 °C. All distilled water filter controls, positive plate controls, and no template plate negative controls performed as expected.

Statistical analyses
The qPCR data was analyzed with R Studio© version 1.2.1335 (2009-2019 R Studio, Inc). Data are expressed as median values to reduce the influence of outlier measurements and plotted with median absolute deviation error. Median C t values for each set of eight technical qPCR replicates representing the DNA from one quarter of a filter were transformed to copies per reaction using the formula derived from each assay's synthetic DNA standard curve. The raw data are in Additional file 2 and graphed in Additional file 3. The median copy-per-reaction values were assessed for normality using the Shapiro-Wilk test and homogeneity of variance using Levene's test. After determining that requirements for normality and homogeneity were not met, non-parametric analyses were carried out. The Friedman repeated measures test was used to determine whether test groups contained significant differences (p ≤ 0.05), and the Wilcoxon Signed Rank test was used to determine pairwise significance between treatments within each group (p ≤ 0.06).

Experiment 1
We evaluated eDNA samples for relatively abundant, naturally occurring chloroplast DNA found in water samples obtained from an outdoor tank. As expected, the filters that were immediately processed ("None" Fig. 2) returned C t values between 20 and 23 (corresponding to ~ 50,000 copies/reaction) for intact samples consistent with previous observations with field water samples [14,15]. The raw data are in Additional file 4. Filters that were stored in ethanol at 23 °C experienced a progressive decrease in eDNA sample quality (as demonstrated by the shift in C t value) across all time points compared to filter samples that were processed immediately. This sample degradation was not seen in the filters that were stored with silica gel beads (Fig. 2). The detection rates of DNA isolated from the 23 °C silica gel bead preserved filters and the filters stored at − 20 or 4 °C in either ethanol or silica gel beads at any time point up to 15 months were stable as indicated by the consistent C t values (Fig. 2). Majaneva et al. [9] compared ethanol to silica gel bead preservation methods for filters destined for metabarcoding analyses.
They only analyzed one storage condition and time point (room temperature for 1 week) and found that silica gel desiccation yielded more consistent community composition than ethanol despite the ethanol samples having a higher concentration of DNA extracted from the filter [9]. Ethanol and silica beads performed comparably for relatively abundant target DNA over the short-term at cooler temperatures, but sample quality deteriorated in ethanol at 23 °C when stored greater than 1 month. At this temperature, we also observed that some ethanol-preserved filters began to physically degrade after 1 month of storage, and the ethanol in several samples evaporated, severely compromising sample quality.

Experiment 2
Across the three different temperature conditions, the eFrog3 test detected significant loss in DNA copy numbers over 12 months at 18 °C and the eLICA1 measured significant loss at both 18 °C and 4 °C (Friedman; p = 0.05; Fig. 3). Low abundance eDNA was preserved equally well up to 1 month regardless of storage temperature. However, a noticeable decrease in detectability was observed at 5 and 12 months when filters were stored at 18 and 4 °C (Wilcoxon; p = 0.06). Sample integrity was maintained to 12 months when filters were stored at − 20 °C (Fig. 3). The raw data are in Additional file 5.

Fig. 2
Relatively abundant eDNA is better preserved on filters desiccated with silica rather than immersed in ethanol (EtOH) at warmer temperature. Transformed cycle threshold ("Transformed C t ") values of IntegritE-DNA ™ qPCR tests targeting chloroplast DNA isolated from filters preserved by EtOH submersion and silica desiccation (n = 2-3) at the indicated temperatures and time periods. C t values were transformed by subtracting the value from 50.001 for more intuitive visualization of the change in DNA quality over time. A clear decrease in DNA quality is observed in the 23 °C EtOH-stored filters. The data are plotted as medians with median absolute deviations (error bars)